Altostratus duplicatus As du
Genus Altostratus, Variety duplicatus
- Photo
- Anna Rümpler
- Location
- Belluno, Veneto, Italy
- Taken
- 25 April 2005
On the left side of the photo, a lower layer is visible beneath a higher layer of Altostratus. This formation (two superimposed layers) is called Altostratus duplicatus.
The weather that day
The sky at nearby weather stations
In the photo: Altostratus duplicatus
As under “Identify”: ✓ = reported by a weather station, dots = estimated from height and cover (automatic measurement). The stations see their own sky – not necessarily the cloud in the photo.
Does the weather fit the cloud?
Altostratus – according to the reanalysis quite possible (21:00) · Why?
- Reanalysis (21:00), quite possible: Middle cloud 97 %. An almost closed middle deck with some precipitation: usually altostratus.
Formation: Thick, extensive layer at middle height formed by large-scale lifting (warm front, low pressure system); often followed by nimbostratus with continuous precipitation.
Observation before model: what an observer at a weather station reported counts for more than an estimate from a station’s instruments and more than the weather model. Each piece of information counts for less the farther away the station and the further from the time of the photo; the strongest comes first. The ERA5 reanalysis (grid point at the photo location, about 25 km grid spacing) only knows the cover per étage and values at the ground – its level is a rough estimate.
Measurements that day
- Temperature
- 9.0 to 14.0 °C
- Precipitation
- 15.0 mm over the whole day
Sources: weather reports from the Integrated Surface Database of NOAA (NCEI), Aviano Ab (32 km SE); ERA5 reanalysis by Copernicus/ECMWF (CC BY 4.0) via Open-Meteo. Times in local time.
Write a comment or ask a question about this photo
Every comment is read before it is published. Your email address is only needed for the confirmation link and a short message once the comment is online; it is deleted after that.